Wednesday, October 22, 2014

Gingerbread Gable Box #SDS-0000279

This box is lots of fun to fill with treats and can be sized quite large because it comes in two pieces. It can also be cut on smaller machines, using a separate piece of paper for the front and back of the box.  The sample shown measures 5 inches high. It was cut on a Silhouette. The front and back pieces were sized to 6.3 x 6.9 inches.


1. Place adhesive on tabs as shown and glue opposite sides together. Tip: Pre-fold all the pieces back and forth to make assembly easier and pre-decorate the front.
2. Fold in the "U" shaped tab first, then the outer tabs. The remaining tab will tuck inside. No adhesive is required for the bottom.
3. Gather handles and tuck into slots on either side of the box.

You can purchase this box at Snapdragon Snippets.  

If you have any questions or concerns about this project, or any other projects, or have a request, please feel free to e-mail me at gallie (AT) I hope you'll visit us on Facebook as well!

Thanks for visiting. Be sure and share what you create.

No comments:

Post a Comment